06-11-2022, 00:55
(06-11-2022, 00:02)Startide a écrit : Ca va dans le dos c'est cela ? cela doit pouvoir s'imprimer en 3D facilement. tu connais le petit nom de cette pièce ?
La CRL offre une photo plutôt pas mal. Des idées des dimensions ?
Dans le CRL il y a ca:
Citation :One, unique shaped greeblie on lower-center part of backplate.
- Bottom of greeblie is in-line with top-line of gold-circuit board-style lines.
- Greeblie is light-gray, curved-open top with oblong shaped bottom with open circle on the upper part of the oblong. Lower oblong has a cut-out design with 1 single narrow curved “loop” in the center (See ref picture)
Et ces photos:https://databank.501st.com/databank/Cost...Back_Armor
De toute façon, il pareil qu'un membre espagnol fait ces pièces pour les AT-AT commanders, donc je suis en contact avec lui pour le moment.
Angel
XO [Garrison Executive Officer]
staff@501stfrenchgarrison.com
-----------------------------------------------------------------
Legion Charter
Operations Protocol
Réglement intérieur de l'association
XO [Garrison Executive Officer]
staff@501stfrenchgarrison.com
-----------------------------------------------------------------
Legion Charter
Operations Protocol
Réglement intérieur de l'association