Projet : Orson Krennic

[Themas JAROME]

Second accessoire pour Krennic... : La ceinture

Coté la CRL...
Belt, Version One, Two, Three and Four
- The belt is constructed from a non-textured leather or leather-like material.
- It is approximately 2" (50.8mm) tall.
- The belt is loopless.
- A single large snap or rivet is visible approximately 1" (25.4 mm) from the buckle.
- The belt is worn with the snap on the right of the wearer.
- The buckle is constructed from a horizontally brushed metal or metal-like material.
- The buckle size is approximately 2 1/2" (65 mm) high and 4" (100 mm) wide with 0.5" (12.7 mm) radius rounded corners.
- Buckle is adorned with an Imperial Code Disk at the center.
Refer to the Imperial Buckle reference page for information on accurate and inaccurate style buckles.

OPTIONAL Level two certification (if applicable):
- Belt is made of leather.
- Between 2" (50.8 mm) and 3" (76.2 mm) tall.
- Buckle has a slight horizontal curve.
- Belt has a groove 1/4" from the top and bottom edge along the length of the belt.
- Belt may hang lower on the right due to the weight of accessories used, if used.

OPTIONAL Level three certification (if applicable):
- Belt has three large loops on the right or back side to hold extra ammunition.
- Three ammunition cartridges are held snuggly within each loop.

Je pense que je vais partir directement par une Certification de niveau 3..
Il ne me manquera que les petit emplacements des munitions. (qui ne devraient pas tarder non plus à arriver)
Voilà ce que donne ma ceinture... Merci à Gian Filippo pour son travail...




Voilà, on va rajouter à la ceinture un emplacement pour trois munitions du blaster et ensuite, le hoster...

Ces deux produits sont en cuir et proviennent de la boutique : DarmansProps.
Merci à Bobby pour son travail.

Bien évidemment, les cartouches que vous pouvez voir sur les photos ne sont pas terminées et proviennent de la boutique de fabrication du blaster en impression 3D.